![]() ![]() When the following information is displayed, enter y. Select Clear the console login password to access the submenu for clearing the console port password.Select Password manager submenu to access the password manager submenu.If you have not obtained the access permission of the document, see Help on the website to find out how to obtain it. The default username and password are available in CloudEngine 16800, 12800, 9800, 8800, 7800, 6800, and 5800 Default Usernames and Passwords ( Enterprise Network or Carrier). Therefore, the display on your device may be different from that provided in this example. The display on different devices in different versions may be different. In Figure 1-1, the CE16800 is used as an example to be connected to the PC. Connect your PC to the device through the console port.After logging in to the device, set a new console port password immediately otherwise, you still need to enter the original password the next time you log in to the device through the console port. The original console port password is still saved in the configuration file. After performing the following operations, install the standby MPU and run the save command to ensure that the configurations on the active and standby MPUs are the same.Īfter restarting the device, you can log in to the device through the console port without entering the password only this time. Do not power off the device when the device restarts.įor CE12800E and CE16800 series switches, if the device has two MPUs, remove the standby MPU. Therefore, back up services and restart the device in off-peak hours. ![]() Restarting the device interrupts services. For example, you can power off and then power on the device to restart the device. You need to restart the device to enter the BootLoader menu. Info: Save the configuration successfully. Now saving the current configuration to the slot 1 Warning: The current configuration will be written to the device. To prevent configuration loss after a device restart, save the device configuration. local-user admin123 service-type terminal local-user admin123 password irreversible-cipher A new user is added. The following example sets the authentication mode to AAA, user name to admin123, and password to system-view.Please configure the login password (8-16)Įnter Password: //Enter the new password.Ĭonfirm Password: //Enter the new password again for confirmation. authentication-mode password set authentication password The following example sets the authentication mode to password authentication.Idx Type Tx/Rx Modem Privi ActualPrivi Auth Int If the current privilege level of a user is 3 or 15, the user has the permission to set a new console port password. The ActualPrivi field indicates the actual privilege levels of users. Run the display user-interface command to display the privilege levels of all users. User-Intf Delay Type Network Address Authen Author Usernameģ4 VTY 0 00:06:53 TEL 10.135.18.67 pass yes Unspecified User-Intf: The absolute number and the relative number of user interfaceĪuthen: Whether the authentication passes The current user interface is marked with an asterisk (*) and is VTY1 in this example. Run the display users command to check all the users who have logged in to the device. Log in to the device using an STelnet or a Telnet account. If you can log in to the device using STelnet or Telnet and your privilege level is 3 or 15, log in to the device using STelnet or Telnet, reset the console port password, and save the configuration. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |